SMART Board 6000S Series Installation And Maintenance Guide

Appendix C Managing the SMART Board 6000S (V3) display using RS-232
smarttech.com/kb/171414 75
Important
Use only a standard RS-232 cable. Do not use a null modem cable. Null modem cables typically have
ends of the same type.
Tip
SMART also offers SMART RemoteManagement cloud-based device-management software, which
you can use to manage SMARTBoard interactive displays with iQ and devices running Windows,
Chrome
™
OS, Android
™
, and iOS operating systems. For more information, see SMART
RemoteManagement.
Configuring the computer’s serial interface settings
Configure the computer’s serial interface before sending commands to the display.
To configure the computer’s serial interface
1. Turn on the display.
2. Turn on the computer, and then start the serial communications program or terminal emulation
program.
3. Activate local echo.
4. Configure the serial interface settings using the following values, and then press ENTER.
Baud rate
19200
Data length
8
Parity bit
None
Stop bit
1
A command prompt (>) appears on the following line, and the display can now accept commands
from the computer.
Note
If no message appears or an error message appears, the serial interface isn’t configured
correctly. Repeat steps 3 and 4.

SMART Board 6000S Series Specifications

General

Resolution	4K UHD (3840 x 2160)
Screen Sizes	65", 75", 86"
Aspect Ratio	16:9
Touch Points	20
Brightness	350 cd/m²
Contrast Ratio	4000:1
Response Time	8 ms
Wall Mountable	Yes
Connectivity	HDMI, USB, VGA, DisplayPort
Operating System	Android