SMART Board 6000S Series - Brightness Commands; Freeze Commands; Input Commands

Appendix C Managing the SMART Board 6000S (V3) display using RS-232
smarttech.com/kb/171414 79
With the exception of get powerstate and set powerstate, commands are available only when the
display is in READY or ON power state.
Input commands
Get command Set command Response
If one display is connected
get input set input[Value]
Where [Value] is one of the following:
l
=hdmi1
l
=hdmi2
l
=hdmi3
l
=vga1
l
=ops1
l
=usbc1
l
=usbc2
l
=android
input=[Value]
Where [Value] is one of the following:
l
hdmi1
l
hdmi2
l
hdmi3
l
vga1
l
ops1
l
usbc1
l
usbc2
l
android
l
none
Brightness commands
Get command Set command Response
get brightness set brightness[Value]
Where [Value] is one of the following:
l
+[Value]
l
-[Value]
l
=[0–100]
brightness=[Value]
Where [Value] is a number between 0
and 100
Freeze commands
Get command Set command Response
get videofreeze set videofreeze[Value]
Where [Value] is one of the following:
l
=on
l
=off
videofreeze=[Value]
Where [Value] is one of the following:
l
on
l
off