Appendix C Managing the SMART Board 6000S (V3) display using RS-232
smarttech.com/kb/171414 80
Screen shade commands
Get command Set command Response
get screenshade set screenshade[Value]
Where [Value] is one of the following:
l
=on
l
=off
screenshade=[Value]
Where [Value] is one of the following:
l
on
l
off
Volume commands
Get command Set command Response
get volume set volume[Value]
Where [Value] is one of the following:
l
+[Value]
l
-[Value]
l
=[0–100]
Note
l
If the display’s audio is muted,
changing the volume also un-
mutes the audio.
l
Setting the volume to zero also
mutes the volume.
volume=[Value]
Where [Value] is a number between 0
and 100
Mute commands
Get command Set command Response
get mute
set mute[Value]
Where [Value] is one of the following:
l
=on
l
=off
mute=[Value]
Where [Value] is one of the following:
l
on
l
off
Firmware version commands
Get command Response
get fwversion fwversion=[Value]
Where [Value] is the firmware version.
To Next Page
Loading...
