SMART Board 6000S Series - Input Commands

Appendix D Managing SMARTBoard 6000S (C)or 6000S series displays using RS-232
smarttech.com/kb/171414 88
Power state Description
POWERSAVE The screen is off, and the display is a very low power state. The display enters
READY or ON state when one of the following occurs:
l
A user presses the Power button on the convenience panel or the remote
control.
l
You send the set powerstate=ready or set powerstate=on command.
This power state is the default energy saving mode for displays set to an EU
location.
Note
The EU uses “standby” to describe this power state.
UPDATEON The display is updating firmware. Do not turn off the display.
UPDATEREADY The display is updating firmware while the screen is off. Do not turn off the
display.
With the exception of get powerstate and set powerstate, commands are available only when the
display is in READY or ON power state.
Input commands
Get command Set command Response
If one display is connected
get input set input[Value]
Where [Value] is one of the following:
l
=hdmi1
l
=hdmi2
l
=hdmi3
l
=vga1
l
=ops1
l
=usbc1
l
=android
Note
The usbc1 set command applies
only to displays equipped with
USB Type-C connectors.
input=[Value]
Where [Value] is one of the following:
l
hdmi1
l
hdmi2
l
hdmi3
l
vga1
l
ops1
l
usbc1
l
android
l
none