Appendix D Managing SMARTBoard 6000S (C)or 6000S series displays using RS-232
smarttech.com/kb/171414 90
Screen shade commands
Get command Set command Response
get screenshade set screenshade[Value]
Where [Value] is one of the following:
l
=on
l
=off
screenshade=[Value]
Where [Value] is one of the following:
l
on
l
off
Volume commands
Get command Set command Response
get volume set volume[Value]
Where [Value] is one of the following:
l
+[Value]
l
-[Value]
l
=[0–100]
volume=[Value]
Where [Value] is a number between 0
and 100
Mute commands
Get command Set command Response
get mute
set mute[Value]
Where [Value] is one of the following:
l
=on
l
=off
mute=[Value]
Where [Value] is one of the following:
l
on
l
off
Firmware version commands
Get command Response
If one display is connected
get fwversion fwversion=[Value]
Where [Value] is the firmware version.
If multiple displays are connected
[Display],@ get fwversion
Where [Display] is the display’s label (A, B, and so on).
@,[Display] fwverversion=[Value]
Where
l
[Display] is the display’s label (A, B, and so on).
l
[Value] is the firmware version.
To Next Page
Loading...
Need help?
General
