Appendix D Managing SMARTBoard 6000S (C)or 6000S series displays using RS-232
smarttech.com/kb/171414 89
Get command Set command Response
If multiple displays are connected
[Display],@ get input
Where [Display] is the display’s label
(A, B, and so on).
[Display],@ set input[Value]
Where
l
[Display] is the display’s label (A,
B, and so on).
l
[Value] is one of the following:
o
=hdmi1
o
=hdmi2
o
=hdmi3
o
=vga1
o
=ops1
o
=android
@,[Display] input=[Value]
Where
l
[Display] is the display’s label (A,
B, and so on).
l
[Value] is one of the following:
o
hdmi1
o
hdmi2
o
hdmi3
o
vga1
o
ops1
o
android
o
none
Brightness commands
Get command Set command Response
get brightness set brightness[Value]
Where [Value] is one of the following:
l
+[Value]
l
-[Value]
l
=[5–100]
brightness=[Value]
Where [Value] is a number between 5
and 100
Freeze commands
Get command Set command Response
get videofreeze set videofreeze[Value]
Where [Value] is one of the following:
l
=on
l
=off
videofreeze=[Value]
Where [Value] is one of the following:
l
on
l
off
To Next Page
Loading...
