SMART Board GX Series Installation And Maintenance Guide

Chapter 4
Maintaining the display
smarttech.com/kb/171744 58
Updating system firmware
The display checks for firmware updates automatically when its turned on, provided the display is
connected to the internet and the Check for updates automatically setting is enabled (see System settings
and Apps on page77). The display notifies you when a firmware update is available.
To make sure the network is configured properly for firmware updates, see Configuring network settings
on page26.
Applying a firmware update
To apply a firmware update
1. After turning on the display, a dialog box appears on the screen asking if you want to update the
display’s firmware.
2. Tap OK to update the display’s firmware.
NOTE
The display may restart a number of times when a firmware update is applied.
OR
Tap Cancel to update the firmware later.
To apply a firmware update from settings
1.
Press the Settings button on the front control panel.
2.
Tap the System Settings icon and tap Check for updates. A message lets you know whether an
update is available.
NOTE
The display may restart a number of times when a firmware update is applied.
3. If an update is available and you'd like to apply it, tap OK. The display applies the firmware update
automatically after a short time.
Updating system firmware manually
You can download system firmware updates at smarttech.com/downloads and update the display's
firmware manually using a USB drive.

SMART Board GX Series Specifications

General

Brand	SMART
Model	Board GX Series
Category	Monitor
Language	English