SMC Networks HRR012-A*-20 Series User Manual

HRX-OM-W002-A
Chapter 5 Display and Setting of Various Functions
5.5 Advanced setting mode HRR Series
5-32
Temperature range monitor start time
24. Press the [▼] key. Displays temperature range monitor start time setting screen
After operation starts, monitoring of the temperature range starts after a set time (sec).
Refer to P.5-27, P.5-28 [Setting example of temperature range monitoring function].
Temperature range time outside monitoring range
25. Press the [▼] key. Displays time outside temperature range setting screen. When the
circulating fluid temperature falls outside the temperature range, if it enters the range
again within the set time (sec) a signal will not occur.
Refer to P.5-28 [Temperature range monitoring function setting example].
Dust filter replacement time
26. Press the [▼] key. Displays dust filter replacement time setting screen.
 Dust filter replacement time
The maintenance time of the dust filter can be set by the user as a reminder to clean
the filter.Maintenance notice "MT.04: Dustproof Filter Maintenance" will be generated
after the set time has elapsed.For maintenance notification, refer to "5.4.4
Notice for maintenance Menu".The factory default setting is 5000 hours. The time
can be set in the range of 1 to 9999 hours.
DI filter replacement time
27. Press the [▼] key. Displays DI filter replacement time setting screen.
RUN
SEC
RUN
SEC
RUN
H
Dust filter replacement time
FLTR ⇒ TIME(Alternately displayed)
RUN
H
DI filter replacement time
DI ⇒ TIME(Alternately displayed)
Temperature range Monitor start time
(setting range ：0 to 9999 sec)
Time outside of temperature range
(setting range：0 to 600 sec)
TEMP ⇒ OUT ⇒START(Alternately displayed)
TEMP ⇒ OUT ⇒OVER(Alternately displayed)

SMC Networks HRR012-A*-20 Series Specifications

General

Brand	SMC Networks
Model	HRR012-A*-20 Series
Category	Chiller
Language	English