4.9 REMOTE HEAVE TAB
Remote heave; Heave is measured by the motion sensor in the installation location. In installations
where heave is to be measured at a different location than the installed location of the motion
sensor remote heave calculation can be used for a virtual mounting location of the motion sensor.
Lever Arm; By entering the mounting location of the motion sensor related the rotational point of
the vessel, Center of Gravity, rotational accelerations will be calculated by the motion sensor and
removed from the calculations. The lever arm should be used in installation where mainly the Z
distance between the rotational point and the mounting location of the motion sensor is big and at
the same time the rate of rotation is high.
To Next Page
Loading...
Need help?
General
