SMC Networks JXCP1 - Output Area Details

- 36 -
(4) Output area details
●Byte0,1: Output port to which signal is allocated
Byte
Bit
Signal name
Description
0
0
IN0
The step data No. instruction the drive will be specified by the
combination of “IN0” to “IN5” (binary digit).
E.g.) Step data No.3 has been assigned
IN5
IN4
IN3
IN2
IN1
IN0
OFF
OFF
OFF
OFF
ON
ON
Caution
Be sure to decide the step data No. via the “IN*” signal before
turning “DRIVE” ON.
Otherwise, the actuator might operate with unexpected step
data.
1
IN1
2
IN2
3
IN3
4
IN4
5
IN5
6
-
Normally, leave it OFF
7
-
Normally, leave it OFF