Snom D385 - Connecting a Headset

14
D385 User Manual Setting up the Phone
Connecting a headset
You can use wired as well as wireless headsets with the phone.
• Wired headsets
If you want to use a wired headset, connect it to the RJ audio jack labeled "
".
Note: If both a wired and a wireless headset are connected to the phone, incoming calls
will go to the wireless headset.
• Wireless headsets
◦ Connecting the base station of your headset via the Snom EHS Adapter.
- Connect the Snom EHS to the connector labeled EHS.
- For more information on how to connect the Snom EHS Advanced and the headset, please
refer to the Quick Installation Guide of the Snom EHS Advanced that came with the device
and to the manual of your wireless headset.
◦ Connecting the headset to the phone via a Bluetooth-compatible adapter.
Insert the adapter into the USB port of the phone. See also the Quick Start Guides of the Snom
USB BT and the Snom HS BT or the manual of the third-party headset.
Attention: The default settings for USB headsets are VID=0a12:PID=100d:HOOK=38/1
for 8.7.2.11 and higher.
- If your phone is running an earlier firmware version, enter these parameters manually on
the phone's web interface at > Advanced > Audio > text field of "Audio parameters". Click
on the question mark
?
to look up the parameters.
- If you are using a dierent headset, whatever the firmware version, enter the parameters
of the headset manually on the phone's web interface at > Advanced > Audio > text field of
"Audio parameters". Click on the question mark
?
to find out which parameters you need
to use for your respective headset.