socomec ATyS Series - Table of Contents

ATyStM - 542931D - SOCOMEC
2 EN
1. GENERAL SAFETY INSTRUCTIONS ...........................................................4
2. INTRODUCTION .............................................................................5
2.1. The ATyS family product range ..............................................................5
2.2. The ATyS M Range Key Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
2.2.1. Selection guide .....................................................................7
3. QUICK START ...............................................................................8
3.1. Quick Start ATyStM ......................................................................8
4. ATYSTM VERSIONS .......................................................................10
4.1. Product presentation .....................................................................10
4.2. Specifications and advantages .............................................................10
4.3. Supply types ............................................................................10
5. OPTIONAL ACCESSORIES ..................................................................11
6. TECHNICAL DATA ..........................................................................12
7. ENVIRONMENTAL CONDITIONS .............................................................13
8. PRODUCT INSTALLATION ...................................................................14
8.1. Changing the padlocking configuration ......................................................14
8.2. Recommanded orientation ................................................................14
8.3. Dimensions .............................................................................14
8.4. Back plate mounted .....................................................................14
8.5. DIN rail mounted ........................................................................15
9. INSTALLATION OF OPTIONAL ACCESSORIES .................................................16
9.1. Auxilliary contacts .......................................................................16
9.2. Voltage sensing and power supply tap .....................................................16
9.3. Bridging bars 4P ........................................................................17
9.4. Terminal shrouds ........................................................................17
9.5. Sealable cover ..........................................................................17
10. INSTALLING WITHIN THE ATYSM ENCLOSURE ..............................................18
10.1. Polycarbonate enclosure .................................................................18
10.1.1. Wiring in a polycarbonate enclosure .................................................18
10.1.2. Extension unit ...................................................................18
11. CONNECTION OF THE POWER CIRCUITS ...................................................19
11.1. Ratings / cross-sections table of correspondence ...........................................19
11.2. Parallel pole set-up for a 4P device used in single phase .....................................19
11.3. Network configurations ..................................................................20
11.3.1. Three phase without neutral network .................................................20
11.3.1.1. Auto-transformer connections .............................................20
12. CONNECTION OF CONTROL/COMMAND CIRCUITS
..........................................21
12.1. Terminal connectors designation ..........................................................22
12.2. Auxiliary contact operating schedule .......................................................23
EN
CONTENT