socomec ATyS Series Installation And Operating Manual

ATyStM - 542931D - SOCOMEC
4 EN
1. GENERAL SAFETY INSTRUCTIONS
• This manual provides instructions on safety, connections and operation of the ATySM transfer switch manufactured by
SOCOMEC.
• Whether the ATyS is sold as a loose product, as a spare, as an enclosed solution or as any other conguration,
this device must always be installed and commissioned by qualied and experienced personnel, in line with the
manufacturers recommendations, following good engineering practices and after having read and understood the
details in the latest release of the relative product instruction manual.
• Maintenance on the product and any other associated equipment including but not limited to servicing operations must
be performed by adequately trained and qualied personnel.
• Each product is shipped with a label or other form of marking including rating and other important specic product
information. One must also refer to and respect markings on the product prior to installation and commissioning for
values and limits specic to that product.
• Using the product outside the intended scope, outside SOCOMEC recommendations or outside the specied ratings
and limits can cause personal injury and/or damage to equipment.
• This instruction manual must be made accessible so as to be easily available to anyone who may need to read it in
relation with the ATyS.
• The ATyS meets the European Directives governing this type of product and includes CE marking on each product.
• No covers other than that for auto/manu on the ATyS should be opened (with or without voltage) as there may still be
dangerous voltages inside the product such as those from external circuits.
• Do not handle any control or power cables connected to the ATyS when voltage may be present on the
product directly through the mains or indirectly through external circuits.
• Voltages associated with this product may cause injury, electric shock, burns or death. Prior to carry out any
maintenance or other work on live parts or other parts in the vicinity of exposed live parts, ensure that the switch
including all control and associated circuits are de-energized.
DANGER WARNING CAUTION
RISK:
Electric shock, burns, death
RISK:
Possible personal injury
RISK:
Equipment damage
• As a minimum the ATySM comply with the following international standards:
- IEC 60947-6-1
- GB 14048-11
- EN 60947-6-1
- VDE 0660-107
- BS EN 60947-6-1
- NBN EN 60947-6-1
- IEC 60947-3
- IS 13947-3
- EN 60947-3
- NBN EN 60947-3
- BS EN 60947-3
The information provided in this instruction manual is subject to change without notice, remains for general
information only and is non-contractual.

socomec ATyS Series Specifications

General

Type	Automatic Transfer Switch (ATS)
Transfer Mode	Open or closed transition
Control	Automatic, Manual, Remote
Standards	IEC 60947-6-1
Communication	Modbus, Ethernet
Protection Degree	IP20
Poles	3 or 4 poles