Need help?Do you have a question about the Soft dB SmartSMS 2 and is the answer not in the manual?
General| Brand | Soft dB |
|---|---|
| Model | SmartSMS 2 |
| Category | Stereo System |
| Language | English |
Guides through the initial installation of the SmartSMS software package.
Instructions for powering on the SmartSMS hardware unit before connection.
Details the process of connecting the SmartSMS unit to the computer via USB.
Describes the setup using a precision microphone and IMIC pre-amplifier.
Details the setup with wireless connectivity for microphone and IMIC.
Explains the setup using a tablet PC for wireless sound masking calibration.
Outlines the procedure for using a sound level meter for measurements.
Step-by-step instructions for starting and launching the SmartSMS software application.
Explains the system status indicators and key operational functions within the software.
Details how the software manages and updates system configuration files.
Overview of the primary interface and its controls for managing the system.
Describes how to adjust sound masking levels using manual or automatic equalization.
Step-by-step guide for performing an automatic equalization process.
Explains how to manually adjust the sound masking levels using a 1/3-octave band equalizer.
Covers setting the desired target masking spectrum for each channel.
Describes how to configure and adjust the active control parameters for automatic volume adjustment.
Covers using the test function to validate equalization and adjust masking sound.
Guides on adjusting measurement input sensitivity for microphones and sound level meters.
Steps for configuring and activating the active controller for automated adjustments.
Addresses issues where the SmartSMS unit is not detected by the software.
Solutions for problems related to USB connection interruptions or failures.
To Next Page