Solid State Logic Nucleus2 User Manual

Nucleus
2
User Guide Page III
Table of Contents
I
ntroduction 1
How to use this Manual 2
Conventions 2
Glossary 2
Software Versions 2
Help! 2
1. Nucleus
2
Overview 3
C
hannel Strip and Mode Switches 3
Centre Section and Analogue Control 4
Nucleus
2
Remote 4
2. Nucleus
2
Configurations 5
DAWs With a Dante Network Connection 5
Multiple DAWs 8
3. Software Installation 9
Software Installation – Mac 9
Software Installation – Windows 11
Using the Dante interface on Nucleus
2
with an existing I/O setup 13
Dante Via Install and Setup 13
Configuration 13
4. Connection and Software Configuration 15
Physical Connections 15
Audio Connections 15
Data Connections 15
Configuring Network Connections 16
Network Wiring 16
Assigning the Nucleus
2
IP Address 16
Direct Network Connection Configuration (Mac) 17
Wider Network with a DHCP Server Configuration (Mac) 17
Direct Network Connection Configuration (Windows) 17
Wider Network with a DHCP Server Configuration (Windows) 17
Connecting Nucleus
2
to Multiple Computers 18
Nucleus
2
Internal Network Architecture 19
IP Address configuration 19
ipMIDI Configuration 20
MIDI Port Mapping 20
Pro Tools 20
Logic Pro 21
Dante Soundcard Configuration 22
Setup 22
Sample rate 23
Stand-alone System vs Wider Dante Network 23
SPDIF I/O & External Soundcard 23
5. Nucleus
2
Remote 25
Establishing the Remote Connection 25
Remote Tabs 26
The DAW Tab 26
The Network Setup Tab 26
The About Tab 26
Remote Layer Selection 27

Solid State Logic Nucleus2 Specifications

General

Brand	Solid State Logic
Model	Nucleus2
Category	Controller
Language	English