Solid State Logic Nucleus2 User Manual

Nucleus
2
User Guide Page 43
MASTER CONTROL
Basic Transport
Your DAW’s transport can be controlled from the stop, play and
record TRANSPORT switches at the bottom of the centre section.
Above the main transport controls are three smaller switches. The
functions assigned to these switches are defined in the Nucleus
2
Remote by selecting the Transport / Utility Soft Key Set. Their
default HUI functions are printed above them, their default MCU
functions are printed below them.
Navigation Controls
The cursor switches (the four arrowed switches with a
central MODE key to the left of the jog wheel) perform
various DAW-specific operations. Please refer to your
DAW’s User Guide for more information.
The large jog wheel performs a number of different
functions, as configured in the Nucleus
2
Remote.
The switch above and to the right of the jog wheel is user
assignable – in protocols which include a function
associated with the wheel, it is assigned to this switch by
default.
The jog wheel’s default function is ‘Wheel’, which is a basic scrolling function in most DAWs. The other modes are FF/RW
and +/– (HUI only timeline scrolling – resolution is controlled by the Timeline format and Nudge value respectively), and
TRACKS which assigns the channel scrolling function to the jog wheel.
Pro Tools Users: Note that the wheel does nothing in ‘ Wheel ’ mode until Jog or Shuttle mode is activated using the
jog wheel switch. Jog or Shuttle mode is assigned to the jog wheel switch via the Transport / Utility page within in
the Nucleus
2
Remote. Jog mode is assigned by default.
Additional Master Controls
The modifier switches to the left of the MONITOR LEVEL control (labelled SHIFT, CTRL, OPT and ALT) as well as the ESC
and ENTER keys above the jog wheel are protocol-specific. Please refer to your DAW’s User Guide for more information.
The SAVE, UNDO, F and F switches above the jog wheel replicate their DAW functions.
All of these switches belong to the Transport / Utility soft key set – each of the functions performed by these switches
can be modified using the Nucleus
2
Remote.
Some of these default assignments will not function with some DAWs.
Also note that the F3 and F4 switches towards the top of the centre section are currently unassigned.
MODE Display (MCU Only)
The two digit MODE display beneath the Nucleus
2
logo displays the ‘Mode’ number within protocols which support this.

Solid State Logic Nucleus2 Specifications

General

Brand	Solid State Logic
Model	Nucleus2
Category	Controller
Language	English