The product is delivered with the current transformers as standard. The current transformers can
be used to measure the export active power. The communication of the current transformers can
be connected to the product through RS485 (see section 6 .7.1, Terminal 2). And the current
transformer also can be replaced by the smart meter.
The smart meter that can be used with this product must be approved by AISWEI. For more
information about the smart meter, please contact the service.
Multifunction Relay
The product is equipped with two multifunction relays as standard. The multifunction relays can
be configured for the operating mode used by a particular system. For more information, please
contact AISWEI service.
Temperature Senser Interface
The product is equipped with one temperature senser interface (see section 6.7.1 ). If the tempera-
ture of the battery need be monitored, the external senser can be connected.
The communication interface for external central grid protection device
The product is equipped with one communication interface (see section 6.7.1 ) to connect the
external central grid protection device. For more information, please contact with AISWEI
service.
Inverter demand response modes (DRED)
The product shall detect and initiate a response to all supported demand response commands
according to the standard AS/NZS 4777.2.
The product only supports the demand response mode DRM 0. The interaction with demand
response enabling device (DRED) can be connected to the terminal block 3 (see section 6.7.1 ). The
Pin 5 and Pin 6 of the terminal block 3 represents the REF GEN/0 and COM LOAD/0.
Ripple control receiver interface
The product is equipped with one interface to connect Ripple Control Receiver device (see
section 6.7.1).
UM0035_ASW05-12kH-T2-T3_EN_V01_0523
To Next Page
Loading...
