Safety 2
2.1 Intended use
• The product is a transformerless hybrid inverter with 2 or 3 MPP trackers and a battery
connection that feeds the direct current of the PV array into the connected battery or
converts it to grid-compliant three-phase current and then feeds it into the utility grid. The
product also can convert the direct current supplied by the battery into grid-compliant
three-phase current. The product has a backup function that can continue to supply select-
ed circuits with power from the battery or PV system in the event of a grid fault.
• The product is intended for indoor and outdoor applications.
• The product must only be connected with PV modules of protection class II (in accordance
with IEC 61730, application class A). Do not connect any sources of energy other than PV
modules to the product.
• The product is not equipped with an integrated transformer and therefore has no galvanic
isolation. The product must not be operated with PV modules which require functional
grounding of either the positive or negative PV conductors. This can cause the product to be
irreparably damaged. The product may be operated with PV modules with frames that
require protective earthing.
• All components must remain within their permitted operating ranges and their installation
requirements at all times.
• Use the product only in accordance with the information provided in the user manual and
with the locally applicable standards and directives. Any other application maycause
personal injury or damage to property.
• The product must only be operated in connection with an intrinsically safe lithium-ion
battery approved by AISWEI. The entire battery voltage range must be completely within
the permissible input voltage range of the product.
• The product must only be used in countries for which it is approved by AISWEI and the grid
operator.
UM0035_ASW05-12kH-T2-T3_EN_V01_0523
To Next Page
Loading...
