The product has been designed and tested strictly according to the international safety require-
ments. As with all electrical or electronical devices, there are residual risks despite careful
construction. To prevent personal injury and property damage and to ensure long-term operation
of the product, read this section carefully and observe all safety information at all times.
DANGER
Danger to life due to high voltages of the PV array or the
battery！
The DC cables connected to the battery or the PV array may be live. Touching the DC
conductors or the live components can cause to lethal electric shocks. If you disconnect the
DC connectors from the product under load, an electric arc may occur leading to electric
shock and burns.
• Do not touch non-insulated cable ends.
• Do not touch the DC conductors.
• Do not touch any live components of the product.
• Do not open the product.
• Observe all safety information of the battery manufacturer.
• All work on the product must only be carried out by qualified personnel who have read and fully
understood all safety information contained in this document and the user manual.
• Disconnect the product from all voltage and energy sources and ensure it cannot be reconnected
before working on the product.
• Wear suitable personal protective equipment for all work on the product.
2.2 Important safety instructions
• Knowledge of all applicable laws, standards and directives.
• Knowledge of and compliance with this document and all safety information.
• The type label must be permanently attached to the product and must be in a legible
condition.
• This document does not replace any regional, state, provincial, federal or national laws,
regulations or standards that apply to the installation, electrical safety and use of the
product.
UM0035_ASW05-12kH-T2-T3_EN_V01_0523
To Next Page
Loading...
