8.5 Setting parameters
8.5.1 Inverter configuration
The Solplanet’s products comply with local grid code when leaving the factory. But you still should
check the grid code and the parameters according to the requirements of the installation site.
Once configuration of the product is completed, the product will start operating automatically.
Description
Function
No.
Grid code
settings
Inverter Details
Function
settings
Choose a safety code. Configure the protection paramete-
rs. Configure the start operation parameters and auotom-
atic reconnection parameters.
Show the general information of the inverter.
Show the present operation value of the inverter.
Active the general function. Active some special function.
➀
➁
Table description
➂
➀
➁
➂
➃
➄
➅
➆
➇
UM0035_ASW05-12kH-T2-T3_EN_V01_0523
To Next Page
Loading...
