Com port
Description Function
RJ45-3
onitor device
RJ45-4
S communication ort
USB USB port
The rmware can be storage in the S disk. The roduct will udate automati-
cally after the USB disk insert to USB interface.
The RS485 interface used to connect the product to the third-party monitor
device. I you dont want to use AiDongle, the thirdarty monitor device can be
used.
RS485 port
RJ45-1
RJ45-2
RJ45-5
RJ45-6
The RS485 interfaces used to the product parallel operation. The straight
through network cable must only be used to connect the parallel inverter as
section 4.9.
The SCA interace used to connect the S attery anage System
o the battery. I the communication interace o the S is CA interace, the
ins or CA interace can be chosen to connect, otherwise the ins or S
interface can be chosen to connect.
Terminal-1
ultiunction elay
Terminal-3
The product is equipped with two multifunction relays as standard. The
multiunction relays can be congured or the oerating mode used by a
articular system. or more inormation, lease contact AISWEI service.
Terminal-2
Terminal can be used to connect the smart meter, PT temerature sensor
and P device voltage and reuency rotecion device. The PI denition is
shown as above table.
Terminal can be use to connect the rile control receiver and Ds device.
The PI denition is shown as above table. Esecially the PI D is a
common port for both device.
Terminal-4
Terminal can be used to connect three current transormer. The PI denition
is shown as above table.
current transformer
Smart eter
PT100 Temperture sensor
UFR Device
Terminal-1
Terminal-2
Terminal-3
Object Description
DO1/DO2
\
DI*4/DR0
Terminal
6pin
4pin
6pin
RS485A
B
1
PI Denition
1
RS485B
A
2
2
B
3
3
A
4
4
5
5
6
6
Smart eter
Ripple Control Receiver Device
DS Device
PT100 Temperture Sensor
UFR Device
ultiunction elay ultiunction elay
Negative
Positive Positive
Negative
CT
6pin
Red Black Red Black Red Black
Terminal-4
Current Transformer 1 Current Transformer 2
Current Transformer 3
Ripple control receiver device
Ds device
UM0035_ASW05-12kH-T2-T3_EN_V01_0523