14
Complete range of IWC radio motors
IWC RTS & io motors - programming and Basic setting Basic
6 Set the DOWN position
7 Confirm end limit setting
8 Recording a transmitter
The motor moves upwards and
stops at the UP position
...motor jogs
...motor jogs
Short simultaneous
press
Press until...
Press the prog button
on the back of the
control until...
2 sec.
4 Place the blind in the desired UP position
5 Set the UP position
Blind goes down Stop at desired
down position
Adjust if neededShort
simultaneous
press
To Next Page
Loading...
Need help?
General
