73
Programming Moco DCE Advanced
Moco DCE
For products equipped with LWE motors
Programming Moco DCE
To change to Li application
Diod EXT
Prog button
Tilt & Li Applications and Li application
(This instruction shows setting via Centralis IB. Setting can be done with RTS control if RTS card is
installed and the channels are programmed)
Moco DCE is default set for Tilt & Li applications
Press and hold
the prog button
for 2 seconds
Press and hold
prog button
for 2 sec
Press and hold the
prog button again for
2 Sec
Press the prog button
repeatedly until...
...the EXT LED
lights up
Release a few
seconds
Li mode is now active
To Next Page
Loading...
Need help?
General
