33
Sonesse 40 WT
Sonesse 40 WT Basic
Setting of end limits
Note!
The position of the motor, to the right or le, and the way the fabric is rolled on the tube,
impacts how to set the limits
Adjust the stop limit
Adjustment screw 1 alters the stop limit in direction 1
Adjustment screw 2 alters the stop limit in direction 2
By turning the screw towards + the number of motor turns increases
By turning the screw towards – the number of motor turns decreases
Don’t use electrical tool to adjust the position.
The motor should be moved away from stop position before limits are altered.
To Next Page
Loading...
Need help?
General
