SOMFY Nina Timer io Installation & Programming Guide

40
Glydea ULTRA 35/60 DCT, Movelite DCT
Curtain track Basic
Press and hold ‘UP’,
‘STOP’ and ‘DOWN’
until...
To enter programming
mode, press ‘UP’, ‘STOP’
and ‘DOWN’ until...
Press and hold
‘STOP’ until...
To confirm new end limit,
press ‘STOP’ until...
...motor jogs ...motor jogs
...motor jogs
...motor jogs
Re-adjustment of end -limits
Programming
Modify motor rotation direction, if needed
Programming instruction for DCT motors
it’s recommended to use Setting tool ref 9014599
OR
OR
OR
Start up, press up
(open) or
down (close)
Place the curtain in the end limit you wish to adjust
Place the curtain in the new desired end limit
Place the curtain
away from the
end limits
At the first command, open or close,
the curtain will make a complete run, open - close,
to record the hard end limits.
OR
OR

SOMFY Nina Timer io Specifications

General

Brand	SOMFY
Model	Nina Timer io
Category	Remote Control
Language	English