27
(Integrated) DC RTS Receiver, Power 1 x 2,5 DC RTS, Power 4 x 2,5 DC RTS
24 V RTS Receivers -Programming and basic settings Basic
Move the blind to the new
desired MY-position
Press until... ...Motor jogs
1 To set a new MY-position, when in Roll up mode
2 Confirm the new desired MY-position
- 3/4 down
5 sec.
With the up and down movement times set,
MY position is pre-set to:
Modify the MY position, in Roll up mode
Move the blind to it’s programmed MY-position
Press until... ...motor jogs
1
2
5 sec.
or or
or or
Remove a programmed MY-position