4
Add or remove transmitters 30
Factory reset 31
Program individual channels to group channel 32
Sonesse 40 WT, Setting of end limits 33
Curtain track 34
Recommendations 34
Motor cable output options 34
Attach motor to rail 34
Wiring guide DCT & RTS 34
Curtain track motors RTS, Programming instruction 35
Connect the RTS transmitter to the motor 35
Check the motor rotation direction 35
Change if needed motor rotation direction 35
Record a RTS transmitter 35
Setting My position 36
Re-adjustment of end -limits 36
Set Touch motion or manual over ride mode 37
Set track speed, default speed = 20 cm/s 38
Add transmitter 39
Reset motor to factory mode, erase all settings 39
Curtain track DCT motors, Wiring control unit to Glydea DCT 40
Glydea DCT, Programming instruction 40
Modify motor rotation direction, if needed 40
Re-adjustment of end -limits 40
Set Touch motion or manual over ride mode 41
Reset motor to factory mode, erase all settings 41
Curtain track WT motors, Wiring instruction 42
Programming instruction 42
Modify motor rotation direction, if needed 42
Back release setting 43
Reset motor to factory mode, erase all settings 43
Advanced
Sun sensor functions 44
Deactivate and activate privacy function 44
Program sun disappearing position 45
Set the motor speed 45
To Next Page
Loading...
Need help?
General
