Sony CX400E - Charging the Battery Pack Using Your Computer

"Handycam" User Guide
PrintSearch
Operation Search
Before use
Getting started
Recording
Playback
Playing images on a TV
Saving images with an external
device
Using the Wi-Fi function
Customizing your camcorder
Troubleshooting
Maintenance and precautions
Contents list
Top page > Getting started > Charging the battery pack > Charging the battery pack using your
computer
Charging the battery pack using your computer
1. Turn off your camcorder and connect the camcorder to a running computer using the Built-in USB
Cable (
).
: To the wall outlet (wall socket)
The POWER/CHG (charge) lamp turns orange.
The POWER/CHG (charge) lamp turns off when the battery pack is fully charged. Disconnect
Built-in USB Cable from your computer.
To charge the battery using an AC-UD10 USB charger/AC Adaptor
(sold separately)
You can charge the battery by connecting the Built-in USB Cable to a wall outlet (wall socket) using an
AC-UD10 USB charger/AC Adaptor (sold separately). You cannot use a Sony CP-AH2R, CP-AL, or AC-
UP100 portable power supply device (sold separately) to charge the camcorder.
Charging time
Approximate time (min.) required to fully charge a fully discharged battery pack.
Battery pack Built-in USB Cable* (when using your computer)
NP-FV50 (supplied) 280
NP-FV70 545
NP-FV100 1,000
The charging times shown in the table above are measured when charging the camcorder at a room
temperature of 25 °C (77 °F). It is recommended that you charge the battery in a temperature range
of 10 °C to 30 °C (50 °F to 86 °F).
* The charging times are measured without using the USB Connection support cable.
To remove the battery pack
Close the LCD screen. Slide the BATT (battery) release lever ( ) and remove the battery pack ( ).
41