Dubbing only desired scenes - Digital program editing
Erasing all programs
(1) Select VIDE() EDIT in tile nlenu settings. Turn the SEL/PUSH EXEC dial to
select ERASE ALL, then press the dial.
(2) Turn tile SEL/PUSH EXEC dial to select EXECUTE, then press tile dial.
All the program marks flash, then tile settings are cancelled.
To cancel erasing all programs
Select RETURN in step 2.
To cancel a program you have set
Press MENU.
The program is stored in memo1T until the tape is ejected.
Note
You cannot operate rerording during the Digital program editing.
On a blank portion of the tape
You cannot set IN o1"OI JT on a blank portion of the tape.
If there is a blank portion between IN and OUT on the tape
The total time eocte may not be displayed correctly.
Make sure your camcorder and VCR are connected, and that the VCR is set to recording
pause. When you use an i.LINK cable (DV connecting cable) the following procedure is
not necessary.
When you use a digital video camera recorder, set its power switch to VCR/VTR.
(1) Select VIDEO EDIT. Turn tile SEL/PUSH EXEC dial to select START, then
press the dial.
(2) Turn the SEL/PUSH EXEC dial to select EXECUTE, then press the dial.
Search for tile beginning of tile first program, then start dubbing.
Tile program mark flashes.
Tile SEARCH indicator appears during search, and the EDIT indicator appears
during edit on tile LCD screen or in the viewfinder.
Tile PROGRAM indicator changes to light blue after dubbing is complete.
When tile dubbing ends, your camcorder and tile VCR automatically stop.
To stop dubbing during editting
Press • using the video operation huttons.
To end the Digital program editing function
Your eamrorder stops when the dubbing is complete. Then the display returns to
VIDEO EDIT in the menu settings.
Press MENU to end the program editing f\mction.
You cannot record on the VCR when:
The tape has run out.
Tile write protect tab is set to expose tile red mark.
Tile IR SETUP code is not correct. (When IR is selected.)
The button to cancel recording pause is not correct. (When IR is selected.)
NOT READY appears on the LCD screen when:
The program to operate the Digital program editing has not made.
i.LINK is selected but an i.LINK cable (DV connecting cable) is not connected.
The power of the connected VCR is not turned on. (when you set i.LINK.)
67
To Next Page
Loading...
