Inserting a scene from a VCR - Insert editing
You can insert a new scene fl'om a VCR onto your originally recorded tape by
specif_?ingthe insert start and end points. Use tile Remote Commander fbr this
operation. Connections are the same as on page 69 or 70.
Insert a cassette containing the desiled scene to insert into the VCR.
[a]
[A]
[B]
[el
[b] [c]
5'
[A]: A tape that contains the scene to be superimposed
[B]: A tape before editing
[el: A tape after editing
(1) Set tile POWER switch to VCR on your camcorder.
(2) On the connected VCR, locate just before the insert start point [a], then press
I I to set the VCR to the playback pause mode.
(3) On your camcorder, locate the insert end point [c] by pressing <1<1 or IH_.
Then press I I to set it to tile playback pause mode.
(4) Press ZERO SET MEMORY on tile Remote Commander. The ZERO SET
MEMORY indicator flashes and the end point of the insert is stored in
memory. The tape counter shows "0:00:00."
(5) On your camcorder, locate the insert start point [b] by pressing <1<1, then press
• REC and the button oil its right simultaneously.
(6) First press II on the VCR, at-td after a few seconds press II on your camcorder
to start inserting the new scene.
Inserting atttomatically stops near tile zero point on the tape counter. Your
camcorder automatically returns to the recording pause mode.
5
ZERO SET
MEMORY
0:00:00
_' ZERO SET
,_,, MEMORY
1
71
To Next Page
Loading...
