Inserting a scene from a VCR - Insert editing
To change the insert end point
Press ZERO SET MEMORY again af'.er step 5 to erase the ZERO SET MEMORY
indicator and begin fl'om step 3.
Using the Remote Commander
In step 5, press OREC and MARK simultaneously, then immediately press ||. And ira
step 6, press II at the scene where you want to start recording flora.
Note
The picture and sound recorded on the portion between the insert start and end points
will be erased when you insert the new scene.
Note on the Remote Commander
Your camcorder works in the commander mode VTR 2. Commander modes 1,2 and 3
are used to distinguish yore camcorder from other Sony VCRs to avoid remote control
misoperation. If you use another Sony VCR in the commander mode VTR 2,we
recommend changing the commander mode or covering the sensor of the VCR with
black paper.
If you insert scenes on the tape recorded with other camcorder (including other
DCR-PC110)
Tbe picture and sound may be distorted. We recommend tbat you insert scenes on a
tape recorded witb your camcorder.
When the inserted picture is played back
The picture and sound may be distorted at the end of the inserted portion. This is not a
malfunction.
The picture and sound at the start point and the end point may be distorted in tbe LP
mode.
To insert a scene without setting the insert end point
Skip steps 3 and 4. Press • when you want to stop inserting.
72
To Next Page
Loading...
