Superimposing a title
If you set the write-protect tab of the tape to lock
You rmmot superimpose or erase the title. Slide the write protert tab to release the write
protection.
To use the custom title
If you want to use the custom title, select [_ in step 2.
If the tape has a blank portion
You cannot superimpose a title oil tile portion.
If the tape has a blank portion in the middle of the recorded parts
The title may not be displayed rorrertly.
The titles superimposed with your camcorder
• They are displayed by only the DV _m'[L_"format video equipment with index titler
f\mction.
• The point you superimposed the title may be detected as an index signal when
searching a recording with other video equipment.
If the tape has too many index signals
You may not be ahle to superimpose a title because the memory is flfll. In this case,
delete data you do not need.
Not to display titles
Set TITLE DSPL to OFF in the menu settings (p. 84).
Title setting
• The title rolor changes as follows:
WHITE *-+ YELLOW *-+ VIOLET *-+ RED *-+ CYAN *-+ GREEN *-+ BLUE
• The title size changes as fiollows:
SMALL *-+ LARGE
You cannot input 13 characters or more in LARGE size. If you input more than 12
characters, the title size returns to SMALL even you select LARGE.
• If you select SMALL, you have nine choices fur the title position.
If you select LARGE, you have eight choices for the title position.
One cassette can have up to about 20 titles, if I title consists of 5 characters
However, if the cassette ineinory is flfll with date, photo and cassette label data, one
cassette can have only tip to about 11 titles with 5 characters each.
Cassette memory capacity is as follows:
6 date data
12 photo data
1 cassette label
If the "_ FULL" mark appears
The rassette n'Jen-lory is fifth Erase the title you do not need.
78
To Next Page
Loading...
