41
Installing Optional Expansion Boards
Chapter 3 Preparations
Output expansion board channel numbers
a) AUX05 and AUX06 are invalid.
b) AUX09 and AUX10 are invalid.
To install I/O expansion boards
Use the following procedure to install expansion boards. (The example figures
show the lower expansion board tray, but the procedure is the same for the upper
tray.)
1
Remove the four screws (+B 3×6) securing the board tray stabilizers, and
remove the stabilizers.
2
As shown in the figure below, push the levers on each end of the expansion
board installation tray to open them, and then pull the tray out.
Installation position on expansion board
installation tray
Lower tray Upper tray
Left Center Right Left Center Right
Whether board can be
installed
No No Yes No No Yes
Output
number
display after
installation
BKDF-960
4 SDI Output
Board
–– AUX03
to
AUX06
–– AUX07
to
AUX10
BKDF-961
2 SD Video
Output Board
–– AUX03
to
AUX04
a)
–– AUX07
to
AUX08
b)
BKDF-962
2 DVI Output
Board
To Next Page
Loading...
