78
Basic Switcher Settings
Chapter 3 Preparations
1
When using the BKDF-901: If the SHIFT button of the DME/SETUP
block is not lit, press it to light it.
When using the BKDF-902: Skip to step 2.
2
Press the INPUT button.
A settings sub menu of the Input sub menu appears in the display panel.
3
Press the h or H button in the numeric keypad until the Setting 1 sub
menu appears.
“Setting1” appears in the sub menu title display area. If it is already
displayed there, you can skip this step.
4
When using the BKDF-901: In the PRESET selection button row, press
the button to which you want to assign a signal.
When using the BKDF-902: In the M/E bus B selection button row, press
the button to which you want to assign a signal.
If you press the SHIFT button before pressing the button to which you want
to assign the signal, you can assign a second signal to that button, in addition
to the signal assigned without pressing the SHIFT button.
5
Rotate the F1 knob to select the signal.
BKDF-901
BKDF-902
To Next Page
