79
Basic Switcher Settings
Chapter 3 Preparations
A list of signal names, specified with the procedure described in “Changing
signal display names” (page 74), appears in the menu screen.
The selected signal is assigned to the selected button.
6
Repeat steps 4 and 5 to assign signals to other buttons.
Using the internal frame synchronizers
Each of the switcher’s input connectors (including those on optional expansion
boards) has an internal frame synchronizer. You can enable these synchronizers
to input video signals that have not been synchronized with other signals.
You can also use the memory of the frame synchronizers to capture still images
from input signals, and use those images in place of normal video input.
When SDI signals (SD-SDI or HD-SDI) are being input and it is selected to
output ancillary data (page 89), no ancillary data will be output if the frame
synchronizers for the corresponding input channels are enabled. To output
ancillary data, disable the frame synchronizers.
To enable frame synchronizers
1
When using the BKDF-901: If the SHIFT button of the DME/SETUP
block is not lit, press it to light it.
When using the BKDF-902: Skip to step 2.
2
Press the INPUT button.
A settings sub menu of the Input sub menu appears in the display panel.
3
Press the h or H button in the numeric keypad until the Setting 1 sub
menu appears.
“Setting1” appears in the sub menu title display area. If it is already
displayed there, you can skip this step.
Note
BKDF-901
BKDF-902
To Next Page
Loading...
