English
16 (E)
Resolution See “3-2-1. Setting resolution”.
Minimum phase difference
MJ100 : 100 ns, MJ110 : 1 µs
See “3-2-3. Output phase difference”.
Compatible head and scale units
PL25 +SL110 , SL130
PL60 +SL331
Length of connecting head cable
Max. 33m
Output signal See Fig. 3-2 and Fig. 3-3.
Reference point signals
Reference point signals are output either during
one cycle of the A/B quadrature signal (Z mode) or
when both the A and B phase signals are high
level (1/4 Z mode), depending on the setting. See
Fig.3-2.
Output circuit
MJ100: Voltage-differential line drivers (MC34C87)
Use the MC34C86 or its equivalent for the receiver
circuit.
MJ110: Open Collector
Maximum response speed
The response speed differs depending on the
phase difference. See “3-5. Maximum Response
Speed” and Fig. 5-1 for the correlation between the
phase difference and the response speed.
External reference point and cable length
SET-P16-1 can be used.
Max. 31.5 m
Alarm signal See “3-6. Alarm signal”.
Power voltage MJ100: DC 4.5 V to 6 V
MJ110: DC 11 V to 31 V
Power consumption
MJ100 : 4 W
MJ110 : 3 W
Temperature Operating: 0 to +45 dC/32 to 113 dF
Storage: –20 to +60 dC/–4 to 140 dF
Mass 350 g
Accessories Output connector ...........................................1 set
Connector cap .................................................... 1
Instruction manual .............................................. 1
Mounting screw .................................................. 2
Ferrite core ......................................................... 1
5. Specifications
PCA, PCB, PCZ, ALARM
U, V, W
*PCA, *PCB, *PCZ, *ALARM
*U, *V, *W
A, B, Z, AL
Maximum rated voltage: 31 V
Maximum rated current: 50 mA
To Next Page
Loading...
