139
Troubleshooting
The handle zoom does not work.
• Set the handle zoom speed switch to FIX or VAR (p. 33).
The access lamp remains lit even after recording was stopped.
• Your camcorder is recording the scene you have just shot on the memory card.
The imaging field looks different.
• The imaging field may look different depending on the condition of your camcorder. This is
not a malfunction.
The actual recording time for movies is less than the estimated recording time.
• Depending on the recording conditions, the time available for recording may be shorter, for
example when recording a fast moving object, etc. (p. 149).
Recording stops.
• Recording may stop if the camcorder is subjected to repeated vibration.
The camcorder does not keep the setting changes.
• Some menu items return to the default setting when the power is turned off.
• The [FOCUS MAGNIFIER] setting is not stored.
• The battery pack or AC Adaptor was disconnected while the power was turned on. Before
disconnecting the battery pack or AC Adaptor, turn off the power and make sure that the
access lamp is turned off.
There is a time difference between the point when the START/STOP button is
pressed and the point that the recording movie actually starts or stops.
• On your camcorder, there may be a slight time difference between the point where you press
the START/STOP button and the actual point that recording movie starts/stops. This is not a
malfunction.
Automatic focus does not function.
• Press the AF/MF button (p. 35) to set the focus to automatic adjustment.
• Adjust the focus manually if the automatic focus does not work properly (p. 35).
The phase detection AF frame display is not visible.
• The camcorder may have switched to contrast AF mode due to the subject conditions or user
settings. This is not a malfunction.
Image stabilization is not working.
• Set [STEADYSHOT] to [ACTIVE] or [STANDARD].
Continued ,
To Next Page
Loading...
Need help?
General
