RM-AAL011
IR
repeater
(not supplied)
STR-DA3300ES
About the
IR
REMOTE jack
You can operate the receiver without pointing
the remote toward the
IR
repeater
of
the
receiver
if
you connect an
IR
repeater (not
supplied) to the
IR
REMOTE jack.
Use an
IR
repeater when you install the
receiver in a place where signals from the
remote cannot reach.
• RS-232C Control
•
ON
The receivercan receive commands from the
RS-232C port.
• OFF
The receiver does not receive commands
from the RS-232C port.
• 12V Trigger
You
can turn the receiver
on/otf
in another
zone, or select various options for use
of
the
12V Trigger function, as explained below.
• OFF
Lets you turn offoutput
of
12V triggers even
when the main receiver is turned on.
•
ZONE
Lets you turn the output
of
12V triggers on
or off based on whether the selected zone
is
turned on or off.
•
CTRL
Lets you turn the output
of
12V triggers on
or
off
manually using the CIS command
of
the
IR
remote.
• INPUT
Lets you turn on the output
of
12V triggers
when the preset input is selected.
When you select "Input," the setting display
which sets each input trigger to on/off
appears. Press
+/+
to select the input, then
press
8)
to check the box.
Tips
• Even when this receiver is standby mode (press
I/C)
on the remote to turned
off
this receiver), the
receiver in zone 2 remains turned on. To
tum
off
all
receivers, press
I/C)
and
AV
I/C)
on
the RM-
AALO
11
remote at the
same
time
(SYSTEM
STANDBY).
•
Only
signals from
components
connected
to the
analog
input
jacks
are
output
through
the
ZONE
2
OUT
jacks.
No signals are
output
from
components
connected
to only the digital
input
jacks.
•
When
SOURCE
is selected, the signals
input
to the
MULTI
CHANNEL
INPUT
jacks
are
not
output
from the
ZONE
2
OUT
jacks
even
when
the multi-
channel input is selected.
The
analog audio signals
of
the
current
function are output.
•
When
"Tuner" is selected; the
same
type
of
radio
station
(FMI
AM)
selected in the main
zone
is set in
zone
2.
However, you
can
select the
input
other
than
"Tuner"
in zone
2.
•
When
the receiver in the main zone is turned off,
or
an input source
other
than
"Tuner"
is selected,
you
can
select a radio station from
AM
or
FM
in
zone
2.
When
two
of
the receivers in the main zone,
zone
2
are turned otf, you can select a
broadcast
from
FMI
AM/XM/SIRIUS
in
one
zone
in
which
the receiver
is turned on.
104
GB
To Next Page
Loading...
