•
Remove
any obstacles in the path
between
the remote
and
the receiver.
• Replace all the batteries in the
remote
with
new ones,
if
they are weak.
•
Make
sure that the
command
modes
of
the
receiver and the
remote
are the same.
If
the
command
mode
of
the receiver
and
the
remote are different, you
cannot
operate
the receiver with the
remote
(page 37).
•
Make
sure you select the correct input on
the remote.
•
When
you operate a
programmed
non-
Sony
component,
the remote may not
function properly
depending
on
the model
and
the
maker
of
the component.
Error messages
If
there is a malfunction, the display shows a
code
of
two numbers and a message. You can
check
the condition
of
the system
by
the
message.
Refer
to the following table to solve
the problem.
If
any problem persists,
consult
your
nearest Sony dealer.
PROTECTOR
Irregularcurrent is
output
to the speakers,
or
the
upper
panel
of
the receiver is covered
with something.
The
receiver will
automatically turn
off
after a few seconds.
Check
the speakers
connection
and
turn
on
the
power
again.
For
other
messages, refer to
"Message
list after
auto calibration
measurement"
(page 48),
"XM
Radio message list" (page 86),
"SIRIUS
Satellite
Radio
message list" (page 86)
and
"DIGITAL
MEDIA
PORT
message
list"
(page 91).
Specifications
AUDIO POWER
SPECIFICATIONS
POWER
OUTPUT
AND TOTAL
HARMONIC
DISTORTION:
With
8
ohm
loads,
both
channels driven,
from
20
- 20,000 Hz; rated 1
00
watts
per
channel
minimum
RMS
power, with no
more
than
0.09% total
harmonic
distortion from
250
milliwatts to rated output.
Amplifier section
POWER OUTPUT
Rated Power Output at Stereo Model)
2)
(8 ohms 20 Hz - 20 kHz,
THD 0.09%):
100W+
100W
Reference Power Output at Stereo Mode
(4 ohms 20 Hz - 20 kHz,
THD 0.15%):
85 W + 85 W
Reference Power Output
(8 ohms I kHz, THD
0.70/0)
FRONT
2
):
110W+I10W
CENTER
2
):
110 W
SURROUND
2
):
110W
+
IIOW
SUR BACK
2
):
110W+IIOW
Reference Power Output
(4 ohms I kHz, THD 0.7%)
FRONT
2
):
100 W + 100 W
CENTER
2
):
100 W
SURROUND
2
):
100W+
100W
SUR BACK
2
):
100W+
100W
Reference sections for clearing
the memory
To
clear
All
memorized
settings
134
GB
See
page
36
I )Depending on the sound field settings and the
source, there
may
be no sound output.
2)Measured under the following conditions:
Power
requirements: 120 V AC, 60
Hz
To Next Page
Loading...
