Notes
on
connecting cables
•
We
recommend that you use a Sony
HDMI
cable.
• We recommend that you use an HDMI,
version 1.3a, category 2 cable with the
HDMI logo (made by Sony) to watch a video
image
of
I080p or higher.
• We do not recommend using an HDMI-DVI
conversion cable. When you connect an
HOMI-OVI conversion cable to a OVI-D
component, the sound and/or the image may
not be output. Connect other audio cords or
digital connecting cords, then set "Input
Assign" in the Input Option menu when the
sound
is
not output correctly.
• Before connecting cables, make sure to
disconnect the AC power cord (mains lead).
Notes
on
HDMI connections
• Check the setup
of
the connected component
if
an image
is
poor
or
the sound does not
come out
of
a component connected via the
HOMI cable.
• An audio signal input to the
HDMI
IN
jack
is
output from the speaker outputjacks,
HDMI
OUT
jack
and
PRE
OUT
jacks.
It
is
not output from any other audio jacks.
• A video signal input to the
HDMI
IN
jack
can only be output from the
HDMI
OUT
jack.
The
video input cannot
be
output from
the VIDEO
OUT
jacks,
or
MONITOR
VIDEO
OUT
jacks.
• The audio and video signals
of
HDMI
input
are not output from the
HDMI
OUT
jack
while the receiver menu is displayed.
• When you want to listen to the sound from
the
TV
speaker, set
"HDMI
Audio" to
"TV
+AMP"
in the
HDMI
settings menu.
If
set to "AMP," the sound is not output from
the
TV
speaker.
• OSO signals
of
Super Audio
CD
are not
input and output.
• Be sure to turn on the receiver when video
and audio signals
of
a playback component
are being output to a
TV
through this
receiver. Unless the power is on, neither
video nor audio signals will be transmitted.
28
GB
• Audio signals (sampling frequency, bit
length, etc.) transmitted from an
HDMIjack
may be suppressed by the connected
component. Check the setup
of
the
connected component
if
an image is
poor
or
the sound does not
come
out
of
a component
connected via the
HDMI
cable.
• Sound may be interrupted when the
sampling frequency or the number
of
channels
of
audio output signals from the
playback component is switched.
•
When
the connected component is not
compatible with copyright protection
technology (HDCP), the image and/or the
sound from the
HDMI
OUT
jack
may be
distorted
or
may not
be
output.
In this case, check the specification
of
the
connected component.
• Refer to the operating instructions
of
each
component connected for details.
To Next Page
Loading...
