•
ZONE
2
If
you are using the surround back speakers
in zone 2, select
"ZONE
2." When you select
"ZONE
2," the input to the
SUR
BACK
jacks
of
the MULTI
CHANNEL
INPUT
is
invalid.
Note
Set "Sur Back Assign" to "OFF," then connect the
surround back speakers to this receiver when you
want to change the connection from a bi-amplifier
connection or a zone 2 connection to a surround
back speakers connection. Re-set up the speakers
after you connect the surround back speakers. Refer
to "Auto Calibration" (page 43) or "Manual Setup"
(page 68).
• Crossover Freq
(Speaker crossover frequency)
Lets you set the bass crossover frequency
of
speakers that has been set to
"SMALL"
in the
Speaker menu. Measured speaker crossover
frequency is set for each speaker after the auto
calibration.
The
adjusted value is set for each speaker
when you adjust the speaker crossover
frequency using "Crossover Freq" after the
auto calibration.
• Multi Ch SW Level
(Multi-channel sub woofer level)
Lets you increase the level
of
the MULTI
CHANNEL
INPUT sub wooferchannel signal
by
+10 dB. This adjustment may be necessary
when connecting a DVD player to the MULTI
CHANNEL
INPUTjacks.
The
sub woofer level from DVD players is 10
dB lower than that
of
Super Audio
CD
players.
• D.Range Comp
(Dynamic range compressor)
Lets you compress the dynamic range
of
the
sound track. This may be useful when you
want to watch movies at low volumes late at
night. Dynamic range compression is possible
with Dolby Digital sources only.
•
OFF
The dynamic range is not compressed.
• STD
The dynamic range is compressed as
intended by the recording engineer.
•
MAX
The dynamic range is compressed
dramaticall
y.
Tips
• Dynamic range compressor lets you compress the
dynamic range
of
the soundtrack based on the
dynamic range information included in the Dolby
Digital signal.
• "STD" is the standard setting, but it only enacts
light compression. Therefore, we recommend
using the
"MAX"
setting. This greatly compresses
the dynamic range and lets you view movies late at
night at low volumes. Unlike analog limiters, the
levels are predetermined and provide a very natural
compression.
• Distance Unit (Distance unit)
Lets you select the unit
of
measure for setting
distances.
• meter
The distance is displayed in meters.
• feet
The distance is displayed in feet.
73
GB
•
To Next Page
Loading...
