You
can select the test tone type.
5 Select the speaker you want to
adjust, then press
(8.
The
test tone
is
output from each speaker
In
sequence.
6 Adjust the parameter using +/+,
then press
(8.
Tips
• To
adjusilhe
level
oj"
all
speakers
al thc
same
limc. press
MASTER
VOL
+/-.
•
The
adjustcd
value is
shown
on
thc display
during
adjustment.
When a test tone
is
not output
from the speakers
•
The
speaker cords may not be connected
securely. Check to see
if
they are connected
securely and cannot be disconnected by
pulling on them slightly.
•
The
speakercords may have the short-circuit
problem.
When a test tone
is
output from
a different speaker than the
speaker displayed on the
screen
The
speaker pattern to the connected speaker
is
not set up correctly. Make sure the speaker
connection and the speaker pattern match.
Test
Tone
menu
parameters
• Test Tone
•
OFF
• AUTO
The
test tone
is
output from each speaker in
sequence.
• FIX
You
can select which speakers will output
the test tone.
• Phase Noise
•
OFF
• LlR, LlC, C/R, RISL, RISR. SRISL, SRI
SBR.
SBRISBL. SRISB, SBLISL. SB/SL.
SLiL. LlSR
Lets you output the test tone sequentially
from adjacent speakers.
Some
items may not be displayed,
depending on the setting
of
the speaker
pattern.
• Phase Audio
•
OFF
• LlR. LlC, C/R. RlSL, RISR, SRISL. SRI
SBR,
SBRISBL, SRISB, SBLlSL,
SB/SL
.
SLlL, LlSR
Lets you output front 2 channel source sound
(instead
of
the test tone) sequentially from
adjacent speakers.
Some
items may not be displayed,
depending on the setting
of
the speaker
pattern.
Other
menu
parameters
of
Speaker
settings
• Sur Back Assign
(Settings of the surround back
speaker(s»
•
OFF
If you have not connected surround back
speakers. select "OFF."
• BI-AMP
If you connect front speakers
in
a bi-
amplifier configuration. select "BI-AMP".
To Next Page
Loading...
