INSTRUCTION MANUAL
SPACE s.r.l.
ER 200 - ER 220
ER150 - ER160 - ER165
Code M0076 - rev.1.6
(04/2005)
Page 38/ 40 SPACE s.r.l. – 10090 Trana (TO) Via Sangano, 48
Tel. (+39) 011/ 933.88.65 – Fax (+39) 011/ 933.88.64
e-mail: info@spacetest.com
After performing the spin, the program shows Figure 50:
Figure 50
Fit 100g on the outside of the wheel, positioning the weight at 12 'o' clock.
In the case of models ER220 /ER160 /ER165, perform the spin by pressing the “F4 key”.
In the case of models ER200 /ER150, turn the wheel manually until normal speed is
achieved.
At the end of the spin, remove the 100g weight from the outside and fit this inside the wheel,
as shown in Figure 51.
IMPORTANT: Fit 100g on the inside of the wheel in the same position of the weight outside,
positioning it
high up on the vertical.
Figure 51
At the end of the spin, remove the 100g weight from the inside and confirm by means of the
“CENTRE key”
Figure 52
Machine calibration is over. The program shows Figure 46. Press the “F1 key” to return to the
initial program page.
To Next Page
Loading...