| Specim IQ User Manual | 51
Advanced Settings
This section describes how to view and modify the Specim IQ settings.
You can open the advanced settings view by pressing the SET button, and selecting Device > Advanced settings.
Figure 79: Advanced Settings View
Allow Raw Data Saving
This section describes how to Allow Raw Data Saving, when recording data on Specim IQ.
If you allow raw data saving, you can you can press the Custom 1 button when recording data, to save RAW data
only.
Proceed as follows:
1.
Press the SET button, and select Device > Advanced settings.
The screen below is opened:
Figure 80: Allow Raw Data Saving
2.
You can allow or deny raw data saving by toggling the Allow raw data saving slider.
Check Calibration
This section describes how to check the Specim IQ calibration.
Calibration check verifies that the calibration of the camera spectral range is correct. Incorrect spectral range leads to
unreliable data.
Before you start, make sure that you have:
To Next Page
Loading...
Need help?
General