SpectraLink 8440 - Page 35

Spectralink 84-Series Series Wireless Telephones Administration Guide
1725-86984-000_P.docx
September 2016 35
Name
Possible Values
DHCP
Enabled, Disabled
If enabled, DHCP will be used to obtain the parameters discussed in DHCP or Manual TCP/IP Setup.
DHCP Boot Server
Enabled, Disabled
A flag to determine if the DHCP server is accessible.
IP Address
Dotted-decimal IP address
The handset’s IP address.
Note: This option is not available when the DHCP parameter is Enabled.
Subnet Mask
Dotted-decimal subnet mask
The handset’s subnet mask.
Note: This option is not available when the DHCP parameter is Enabled.
IP Gateway
Dotted-decimal IP address
The handset’s default router.
AC Required
Yes, No
A flag to determine if handsets will connect only to APs (access points) that enforce access control (Wi-Fi
Multimedia Admission Control [WMM-AC]). (See Caution note below.)
SSID
string
The Service Set Identifier (SSID) of the wireless network.
Security
0=No security, 1=WEP, 2=WPA-PSK, 3=WPA2-PSK, 4=WPA2-
Enterprise
The wireless security mode.
WEP
See WEP Menu.
WPA(2)-PSK
See WPA (2) PSK Menu.
WPA2-Enterprise
See WPA2-Enterprise Menu.
Radio
See Radio Menu.
Caution: WMM-AC not supported by 87-Series handsets
When deploying both 84-Series and 87-Series handsets in the same facility using
the same Wireless LAN, Wi-Fi Multimedia Admission Control (aka access control,
AC or WMM-AC) must be disabled in any handset parameters and APs as it is not
supported by 87-Series handsets. Any parameter that requires or enforces AC
must be disabled.