SpectraLink 8440 - Page 64

Spectralink 84-Series Series Wireless Telephones Administration Guide
1725-86984-000_P.docx
September 2016 64
Parameter
Permitted Values
Default
reg.x.fwd.noanswer.contact
string
Null
The forward-to contact used for calls forwarded due to no answer. If Null, the contact specified by
divert.x.contact will be used.
reg.x.fwd.noanswer.ringCount
0 to 65535
0
The number of seconds the handset should ring for before the call is forwarded because of no answer. Note: The
maximum value accepted by some call servers is 20.
reg.x.fwd.busy.status
0 or 1
0
If 0, incoming calls that receive a busy signal will not be forwarded. If 1, busy calls are forwarded to the contact
specified by reg.x.fwd.busy.contact.
reg.x.fwd.busy.contact
string
Null
The forward-to contact for calls forwarded due to busy status. If Null, the contact specified by divert.x.contact
will be used.
1
Change causes handset to restart or reboot.
Example Call Forwarding Configuration
In the example configuration shown next, the call forwarding parameters for registration 1 have
been changed from the default values.
 The forward-always contact for registration 1 is 5557 and this number will be used if the
parameters divert.busy, divert.dnd, or divert.noanswer are not set.
 Parameters you set in those fields will overrule divert.1.contact.
 To enable these three divert options for each registration, you will need to enable the
divert.fwd.x.enabled parameter and the .enabled parameter for each of the
three forwarding options you want to enable.
 In this example, divert.fwd.1.enabled has been disabled; all calls to registration 1
will be diverted to 5557 and you do not have the option of enabling any of the three
forwarding options on the handset.
 The three divert options are enabled for registration 2 in the divert.fwd.2.enabled
parameter, giving you the option to enable or disable any one of the three forwarding
options on the handset.
 When do not disturb (DND) is turned on, you can set calls to registration 2 to be diverted
to 6135559874 instead of 5557.
 The parameter divert.noanswer.2.enabled is enabled so that, on the handset,
you can set calls to registration 2 that ring for more than 15 seconds, specified in
divert.noanswer.2.timeout, to be diverted to 2987, as set in
divert.noanswer.2.contact.