Basic Configuration
RAC2V1A Router User Guide 16
3. Enter the user name and password, and click Apply to sign in. These
default sign-in credentials appear on the label on the back of the
router. The Basic Wireless Settings screen displays.
Note: The default user name and the default password are both
“admin”. Both are in lower case letters.
4. Set basic setup configuration parameters as required for the system.
Note: Most configuration parameters that you may want to set can be
accessed on the Basic Wireless Settings screen or on the LAN Setup or
Wireless tabs.
Configuring the Wireless Network
Perform the following steps to make the basic configuration settings for
the wireless network.
Enabling or Disabling the Wireless Network.
By default, the router is shipped with a default Wi-Fi network name and
Wi-Fi password for both 2.4 GHz and 5 GHz, as well as WPA2 security.
You can find this network name and password on the label on the back
of your router.
Perform the following steps to disable or re-enable the wireless network.
1. Access and sign in to the configuration interface.
2. Click the Basic Setup tab.
3. Click the Enable SSID checkbox in either the Wireless 2.4 GHz
section or the Wireless 5 GHz section to enable wireless networking
for that frequency.
4. Click Apply.
Changing the Administrator Password
You should change the administrator password to something other than
the default password so that unauthorized users cannot access your
configuration interface.
Note: When you first set up your router, the default user name and the
default password are both “admin”. Both are in lower case letters.
Perform the following steps to change the administrator password.
1. Access and sign in to the configuration interface. See
Accessing the
Configuration Interface
(page 15) for more information.
2. Click the Utilities tab.
To Next Page
Loading...
