Advanced Configuration Options
RAC2V1A Router User Guide 21
5. Enter the Start IP Address and End IP Address for the range of IP
addresses that the DHCP Server running on the route will be allowed
to assign to a network device.
6. In the Lease Time field, select the time before the assigned IP
address will expire. (After the lease time is up, the user is
automatically assigned a new dynamic IP address.)
Note: Refer to
LAN Setup
(page 39) for specific instructions on
setting the various DHCP configuration parameters.
7. Click Apply at the bottom of the screen.
Configuring DHCP for IPv6
Perform the following steps to configure DHCP for IPv6.
1. Access and sign in to the configuration interface.
2. Click the LAN Setup tab.
3. Click LAN Settings (IPv6) in the side menu to display the LAN
Settings screen.
4. Click the Enable checkbox under LAN Settings (IPv6).
5. Enter the Start IP Address and End IP Address for the range of IP
addresses that the DHCP Server running on the route will be allowed
to assign to a network device.
6. In the Lease Time field, select the time before the assigned IP
address will expire. (After the lease time is up, the user is
automatically assigned a new dynamic IP address.)
Note: Refer to
LAN Setup
(page 39) for specific instructions on
setting the various DHCP configuration parameters.
7. Click Apply at the bottom of the screen.
Adding and Deleting Reserved DHCP Clients
The Client List screen shows the IP address, host name and MAC
address of each computer that is connected to the network. If a
computer does not have a specified host name, then the host name field
will be blank.
Perform the following steps to configure the DHCP Clients.
1. Access and sign in to the configuration interface.
2. Click the LAN Setup tab.
To Next Page
Loading...
Need help?
General
