Installation and Reference Manual
324
Installation and Reference Manual v3.2/0410/6
A value from 0 to 15 where 0 is the best value. If in doubt set it as 1, equates to values in RIP.
Enable/Disable. Enables the negotiation of Multilink. Some products abandon a call/link if asked to
negotiate. Typically set to Enable
Maximum Reconstructed Reception Unit
Specifies the maximum number of octets in the Information fields of reassembled packets, typically set to
1500
The negotiated packet size that can be received from a Multi Link PPP connection typically set to 1500
Short (2 bytes) or Long (4 bytes). To negotiate whether short or long sequence numbers will be allowed
for a packet. Recommend Short is used to reduce the overhead on the system.
PAP Password Authentication Protocol, provides a simple method for the peer to establish its
identity using a 2-way handshake. This is done only upon initial link establishment
Chap Challenge-Handshake Authentication Protocol is used to periodically verify the identity of the
peer using a 3-way handshake, and therefore is more secure. This is done upon initial link
establishment, and MAY be repeated anytime after the link has been established
Authentication is only verified in one direction.
Outgoing Authentication is only verified in one direction
Bothway Authentication is verified in both directions.
On Demand page
Min. Call Time
Specifies the amount of time the call should connected before closing through inactivity
Specifies the time period a link needs to be idle before the Call Server will close the connection
Active Session Idle Period
The amount of time (in seconds) the connection will stay up when a session is open across the link (eg
Telnet, browser to far end is open) but there is no data transfer (ie the open session is idle).
Not used
Specifies the number of ISDN Channels the Call Server should use on initial dial up
To Next Page
Loading...
