ST G3-PLC - Figure 5. Node Tree Panel

Getting started UM1811
10/52 DocID026814 Rev 1
Figure 5. Node tree panel
All the services provided by one layer may be accessed from the main menu or from one of
its sub menus. Below here there is a brief description of each main menu:
 PHY: the PHY menu offers an interface to use the PHY primitives of the G3-PLC
protocol.
 MAC: the MAC menu offers an interface to use the MAC primitives of the G3-PLC
protocol.
 ADP: the ADP menu offers an interface to use the 6LoWPAN primitives of the G3-PLC
protocol.
 BOOT: the BOOT menu offers an interface to use the ST defined bootstrap application.
This feature will not be described in this document. Please contact your ST local
support for additional information.